BSTP 01 is an integral stainless steel urinal with an automatic flushing system using a thermal sensor for non-contact control, which responds to temperature changes in the siphon after using the urinal. This thermal sensor generates a signal analyzed by the electronics, opens the solenoid valve and flushes the urinal. After 24 hours of inactivity, the urinal rinses itself.
The heat sensor does not respond to people standing near or passing by the urinal. The rinsing time setting is performed without the remote control. It is set by turning off the power according to the operating instructions.
A urinal with battery power and sensor control is supplied at the customer’s request.
This device is easily installed by connecting and hanging on the wall.
The flushing system is protected from mechanical damage, as all parts are located under the urinal cover.
Due to its resistance to damage, it is intended mainly for installation in prisons, penitentiaries and other places where safety is the main required parameter.
Basic technical characteristics:
- water supply: 1/2 “
- water pressure: 0.1-1.0 MPa
- adjustable rinsing time: 1-20 sec. (factory 5 sec.)
- drain: d = 50 mm
- power supply: 12 V, 50 Hz
- power required: 6 VA
- power source: safety power transformer
ZAC 1/20 (max. 3xBSTP 01)
ZAC 1/50 (max. 8xBSTP 01)
- weight: 8 kg
- Stainless steel urinal. steel
- Thermal sensor
- Solenoid valve
- Angle valve with filter
- Siphon and connecting pipes
Conditions for erecting the structure
- Install water supply, 1/2 “pipe
- Set the drain – d = 50
- Install the power cable – 12 V, 50 Hz from the safety power transformer ZAC
A – supply
C – el. voltage
D – drainage
E – syphone with smart scanner