Heat pump regulator Avansa 110 C

The AVANSA 110-C thermostat is designed to control a heating pump. The task of the thermostat is to turn on the pump when the temperature exceeds the set value and turn it off if the boiler cools down. This avoids unnecessary pump operation, which allows you to save electricity (up to 60% can be saved depending on the use of the boiler) and extend the service life of the pump. This increases reliability and reduces maintenance costs. The pump start temperature is set using a potentiometer (in the range of 10 … 90 ° C). The pump is switched off if the measured temperature falls 5 ° C below the set temperature. Switching the pump on and off takes place after approx. 30 seconds – this prevents the pump from switching on when sudden temperature changes occur. In addition to the potentiometer, the regulator has 2 switches. The first is used to turn the controller on / off (marked with a red diode). The second is for manual pump switching (green diode).

• Supply voltage: 230V 50Hz ± 10%
• Temperature setting range: 10 … 90 ° C
• Hysteresis: 10 … 90 ° C
• Power consumption: <2W
• Operating temperature: -10 … + 50 ° C
• Connection cable: 3 x 0.75mm
• Sensor length: 1.2 m
• Dimensions: 75 x 50 x 132 mm
• Degree of protection: IP20